2-step post processing
Delivering professional results every time
Finish your 3D prints with our wash and cure units. Our wash units remove all excess resin highly efficiently and our cure units strengthen your parts to deliver maximum material properties.

Step 1
Post expose on the platform to maintain dimensional accuracy. Transfer platform to your Photocentric Wash unit.

Step 2
Transfer the clean platform to Photocentric Cure unit.
Afterwards parts are ready for use.
Post processing large volumes of prints
The Air Wash L is designed for large scale production. Its air agitation system cleans very effectively when used with our resin cleaner. The Cure L2 takes a full Magna platform and will cure it effectively with both light and heat.
The perfect 3D printing post processing combination for large volume production.

Photocentric Air Wash L

Using Air Agitation
90L, 20G wash unit

Increase throughput with 24/7 operation
Air Wash L can operate 24/7

Plug and Play
Easy to setup

Streamline the process
Designed to hold the entire Liquid Crystal Magna platform with full z build volume

A more thorough clean
Millions of bubbles contact the prints delivering a thorough clean

Clean in one process
Washes both the printed parts and platform together
Photocentric Cure L2

Large Chamber Volume
Cure L2 takes a full Magna platform so you can post-expose on platform.

Time regulated control
Digital timer control, set the time and leave your prints to cure.

Strong Parts with peak properties
Your printed parts will be dry and strong with ultimate material properties.
Dedicated wash and cure units designed to complement Liquid Crystal Opus
Photocentric Wash 15 unit is ideal for removing resin from detailed prints. Use with our Photocentric resin cleaner which is formulated to give superior results and mark free finishes.
Photocentric Cure M+ optimises strength, drying the models to maximise their material properties.

Photocentric Wash 15

Transfer your platform
Wash 15 accommodates full platform parts up to 300 x 275 x 120mm.

Reduce downtime
Wash 15 can perform 140 cleaning cycles before changing fluid.

15L Capacity
Photocentric Cleaner volume.
Photocentric Cure M+

Large chamber volume
Cure M+ takes full Liquid Crystal Opus platform eliminating the need to remove parts beforehand.

Time regulated control
Digital timer control, set the time and leave your prints to cure.

Strong Parts with peak properties
In 20 minutes your printed parts will be dry and strong with maximum material properties.
Photocentric Resin Cleaner
10 minutes and your models are clean
Superior washing to IPA with better health and safety.
Clean models, platforms and vats
Resin Cleaner cleans your printer accessories as well.
Multiple use
No need to refill or filter after every printer.
White marks are no longer an issue
No cloudy or white spots.
Note cleaner not suitable for use with our Flexible resin range.
Part on right washed with Photocentric resin cleaner compared to IPA on the left.